MLG 33 sealer (two-part seam sealer) is designed for Mannington products with low-gloss vinyl or urethane-based wearlayers. A properly sealed seam will be as strong as the surface of the floor covering, and will remain intact for the life of the floor. The Versatile Sealing Tip (VST-96) is included in this kit.
Carpet Express recommends a floorcovering professional to determine the amount of flooring you should purchase. Computer screen colors may vary from actual material. Please view actual samples to ensure your satisfaction.
|Prior to sealing, be certain all seams are clean, dry, and free of adhesive contamination. Part B, which contains the de-glossing agent, must be shaken vigorously beforeblending with Part A. Empty entire contents of Parts A and B into the supplied applicator bottle. After securing the VST tip to the applicator bottle, gently shake the bottle to mix the ingredients. After mixing, the bottle should stand until all trapped air bubbles have dispersed, typically 15 minutes. Prior to use, check the flow of the sealer on a scrap piece of flooring. Use the forefinger of one hand on top of the flat portion of the tip to guide and ensure proper fin penetration. Use the other hand to control sealer flow. Hold the bottle at approximately a 45ø angle. Lightly squeeze the bottle to apply a uniform bead of sealer approximately 1/8" wide centered on the seam cut. It is crucial that the seam sealer penetrate the full thickness of the seam cut to ensure a proper chemical weld. Allow the sealed seam to dry before traffic can be allowed on the floor. Do not walk onor move heavy furniture directly over the sealer until it is fully dry. We recommend 24 hours. Mark the seam by placing a scrap piece of flooring along each side of the seam.MLG 33 cannot be saved for reuse. Safely discard any unused sealer.|
|One kit of MLG 33 will seal approximately 70 lineal feet of seams.|